4006 Gig Ethernet, 1000SX mod, Sup III implementation
We are in the preparation phase, getting ready to implement a new Catalyst 4006 CORE Switch, with 1 - WS-X4448-GB-RJ45 module, 1 - WS-4148-RJ module, 2 - WS-X4306-GB modules and a Supervisor III Module.
I would like to find some GOOD references for implementation and IOS configuration, but have yet to locate anything worthwhile.
Does anyone know of some good Technical references for the 4006??
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...