12-08-2001 02:58 AM - edited 03-01-2019 07:40 PM
How to configure the L3 module for inter vlan routing.How the two physical gbic port can be used.
How the switch can be configured to communicate with the router(L3)module.Any website address or any config? Thanks.
12-08-2001 10:15 AM
The below URL lists all the FAQs and sample configs for lan technologies
http://www.cisco.com/warp/public/473/
and your specific question is available at
12-09-2001 12:00 AM
How should we configre the external gbic ports on the L3 module as an uplink to the vlan in a 3524 switch.
12-09-2001 06:49 PM
It's going to take a little reading, and checking out the sample configs. You should read up on things with the links that bsivasub provided.
The short story is to make the L3 vlan interfaces to match the VLANs in the 3524 (assuming you configure a VTP domain that both subscribe to). Once you do that, assign both switchs' GBIC ports to the desired VLAN, hook them up, and then configure your L3 module just as you would if the 3524 switch wasn't there.
If that doesn't make sense, it *reading time*!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide