When trying to connect to the RSM so that I may configure inter-vlan routing I am unable to use the ' Session 2' command. I says it is 'Trying IntlgLineCard-2' and then comes back with a 'Session: Unable to tunnel to IntlgLineCard-2' error. What am I doing wrong? I was not the person who built this switch so I do not know any history and my last Cisco instructor said the module should be auto recognized. I am always a little hesitant when the word 'auto' is used. Please advise....Thank you in advance!
Is your Layer 3 module booted up fine? Can you console it and check? If it's in rommon, boot from bootflash(if you have an IOS image). Also paste the output of show module. Also take a look at CSCds08233
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: