When trying to connect to the RSM so that I may configure inter-vlan routing I am unable to use the ' Session 2' command. I says it is 'Trying IntlgLineCard-2' and then comes back with a 'Session: Unable to tunnel to IntlgLineCard-2' error. What am I doing wrong? I was not the person who built this switch so I do not know any history and my last Cisco instructor said the module should be auto recognized. I am always a little hesitant when the word 'auto' is used. Please advise....Thank you in advance!
Is your Layer 3 module booted up fine? Can you console it and check? If it's in rommon, boot from bootflash(if you have an IOS image). Also paste the output of show module. Also take a look at CSCds08233
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...