I have 2 4006 switches that are connected via Multi-Mode Fiber on ports 1/1-2 on their respective sup II engines. Here's my question.... From Switch - A the 'show port channel 1' shows ports 1/1-2 connected desirable silent mode. I then telnet to Switch - B which shows ports 1/1-2 connected in auto silent mode. Is this a CISCO recomended Channel Mode for those ports? The purpose of this config is to have a 2 GIG link between the two switches. Does anyone have any advice?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...