Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

4006 SIII and IPX-routing

Hi

I have a Cat 4006 with a Sup III engine and I really need to get IPX routed.

Is it possible to connect an external router and route IPX "on-a-stick".

I read that there will be a new release of software in August but I cannot wait.

Tanks

//Tom

4 REPLIES
New Member

Re: 4006 SIII and IPX-routing

...oops

I mean Thank You (the "edit" link never showed up)

//Tom

Cisco Employee

Re: 4006 SIII and IPX-routing

Yes. You can trunk to an external router and configure sub-interfaces and do IPX routing on the router

Regards,

-Prashanth

New Member

Re: 4006 SIII and IPX-routing

I have the same problem and I can use a 7204 VXR as the "stick-router". Can any one show me a configuration example with a few VLANs.

I use the 4006 to route IP. I connect my 7204´s FE0/0 interface to int GE3/1on 4006 to route IPX.

New Member

Re: 4006 SIII and IPX-routing

IPX routing available in supIII in the august/september release is limited low kpps software switching. So router on a stick or mainly IP implementation is what this box is intended for.

99
Views
0
Helpful
4
Replies
CreatePlease to create content