Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
240
Views
0
Helpful
1
Replies

4148RJ-45 card

algarza
Level 1
Level 1

‎04-13-2004 06:57 PM - edited ‎03-02-2019 02:58 PM

On three separate occasions, one of the WS-X4148-RJ cards on a 4506 chassis goes into "inactive" state. Any thing connected on this module stops communicating. When I accomplish the command "show port status", instead of the usual connected/not connected I see "INACTIVE". Only until this module is issued the command "RESET", do all devices communicate once again. Anyone seem this particular problem ???

Labels:
0 Helpful
1 Reply 1

Prashanth Krishnappa
Cisco Employee
Cisco Employee

‎04-18-2004 04:54 PM

Can you paste the output of sh mod and sh port status(if you have saved a copy?

A port would normally show inactive state if it does not get VLAN info? Is this switch a VTP client? When the problem happened did the trunk to the VTP server go down?

0 Helpful
Customers Also Viewed These Support Documents