07-12-2006 07:00 AM - edited 03-03-2019 04:01 AM
We need to use the SFP ports on the supervisor modules, problem is that they are on inactive rather than nonconnect.
Probably an easy one...
switch#sh mod
Chassis Type : WS-C4510R
Power consumed by backplane : 40 Watts
Mod Ports Card Type Model
---+-----+--------------------------------------+--------------
1 6 Sup V-10GE 10GE (X2), 1000BaseX (SFP) WS-X4516-10GE
2 6 Sup V-10GE 10GE (X2), 1000BaseX (SFP) WS-X4516-10GE
3 48 10/100BaseTX (RJ45)V, Cisco/IEEE WS-X4248-RJ45V
4 48 10/100BaseTX (RJ45)V, Cisco/IEEE WS-X4248-RJ45V
5 48 10/100BaseTX (RJ45)V, Cisco/IEEE WS-X4248-RJ45V
switch#sh int status mod 1
Port Name Status Vlan Duplex Speed Type
Te1/1 notconnect 1 full 10G No X2
Te1/2 inactive 1 full 10G No X2
Gi1/3 inactive 1 full 1000 1000BaseLH
Gi1/4 inactive 1 full 1000 1000BaseLH
Gi1/5 inactive 1 full 1000 1000BaseLH
Gi1/6 inactive 1 full 1000 1000BaseLH
07-12-2006 07:38 AM
Hi Mark,
Simply configure "hw-module uplink select gigabitethernet"
documented here:
HTH,
Bobby
*Please rate helpful posts.
05-24-2018 11:01 AM
I can't access that document. Do you have a link which is publicly accessible?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: