Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4506 Monitoring Ports

We are installing sniffers on our network and I wanted to make sure I got the commands right for setting up the monitoring port on out 4506. Are they:

Switch(config)# monitor session 1 source interface fastethernet 4/10 (Router Port)

Switch(config)# monitor session 1 destination interface fastethernet 4/15 (Sniffer port)

1 REPLY
Silver

Re: 4506 Monitoring Ports

I think your commands are sufficient for more features follow this

To start a new ERSPAN, SPAN, or RSPAN session, add or delete interfaces or VLANs to or from an existing session, filter ERSPAN, SPAN, or RSPAN traffic to specific VLANs, or delete a session, use the monitor session command. Use the no form of this command to remove one or more source or destination interfaces from the session, remove a source VLAN from the session, or delete a session.

monitor session session source {{interface type} | {{vlan vlan-id} [rx | tx | both]} | {remote vlan rspan-vlan-id}}

monitor session session destination {{interface type} | {vlan vlan-id} | {remote vlan vlan-id} | {analysis-module slot-number} | {data-port port-number}}

monitor session session-number filter vlan vlan-range

monitor session servicemodule mod-list

monitor session session-number type {erspan-source | erspan-destination}

no monitor session {{range session-range} | local | remote | all | session}

no monitor session session source {{interface type} | {{vlan vlan-id} [rx | tx | both]} | {remote vlan rspan-vlan-id}}

no monitor session session destination {{interface type} | {vlan vlan-id} | {remote vlan vlan-id} | {analysis-module slot-number} | {data-port port-number}}

1218
Views
0
Helpful
1
Replies