07-07-2003 07:52 PM - edited 03-02-2019 08:41 AM
I installed a WS-X4448-GB-RJ45 module on our 4506 switch.
The switch has IOS version 12.1.13EW
Super engine IV (WS-X4515)
"show module X " and "show diag online module X" said everything is OK.
But the module LED was red.
PC connect to this module can ping outside. change the module to other slot, same problem.
07-07-2003 08:01 PM
What was the status of the interface itself? Can you paste the output of sh interface gig x/y, sh mod and sh diag module online x?
07-07-2003 08:07 PM
Interface LED was green.
AIC4506#show module 2
Mod Ports Card Type Model Serial No.
----+-----+--------------------------------------+-----------------+-----------
2 48 10/100/1000BaseTX (RJ45) WS-X4448-GB-RJ45 JAB07250787
M MAC addresses Hw Fw Sw Status
--+--------------------------------+---+------------+----------------+---------
2 000d.2884.7190 to 000d.2884.71bf 1.1 Ok
AIC4506#show diag online module 2
Slot Ports Card Type Diag Status Diag Details
---- ----- -------------------------------------- ---------------- ------------
2 48 10/100/1000BaseTX (RJ45) Passed None
Detailed Status
---------------
. = Pass U = Unknown
L = Loopback failure S = Stub failure
I = Ilc failure P = Port failure
E = SEEPROM failure G = GBIC integrity check failure
Ports 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
. . . . . . . . . . . . . . . .
Ports 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32
. . . . . . . . . . . . . . . .
Ports 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48
. . . . . . . . . . . . . . . .
AIC4506#show ver
Cisco Internetwork Operating System Software
IOS (tm) Catalyst 4000 L3 Switch Software (cat4000-IS-M), Version 12.1(13)EW, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Fri 20-Dec-02 13:52 by eaarmas
Image text-base: 0x00000000, data-base: 0x00E638AC
ROM: 12.1(12r)EW
Dagobah Revision 71, Swamp Revision 28
AIC4506 uptime is 9 minutes
System returned to ROM by power-on
System image file is "bootflash:cat4000-is-mz.121-13.EW.bin"
cisco WS-C4506 (XPC8245) processor (revision 7) with 524288K bytes of memory.
Processor board ID FOX07150077
Last reset from PowerUp
50 Gigabit Ethernet/IEEE 802.3 interface(s)
403K bytes of non-volatile configuration memory.
Configuration register is 0x2102
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide