03-13-2006 03:36 AM - edited 03-04-2019 03:01 AM
Hi
I have a cisco 4507 catalyst switch.
I want enable IP Classless in global mode.
But i can not do it becuse like no command in this switch.
------------------------
Cisco Internetwork Operating System Software IOS (tm) Catalyst 4000 L3 Switch Software (cat4000-I9S-M), Version 12.2(20)EWA3,
RELEASE SOFTWARE (fc1)
--------------------
So my question is can I not enable Ip classless command in cisco4507 switch?.
or if possible then how ?
any expert help me ?
thanks
Biplob
03-13-2006 03:39 AM
Hi,
I think you will find that the reason you cannot configure the 'ip classless' command is because the switch always operates in a classful manner and you don't have the option of enabling classless routing.
Hope that helps - pls rate the post if it does.
Paresh
03-13-2006 03:49 AM
Hello,
It should be possible to have the switch operate in a classless manner. Do you have ip routing enabled?
Refer to this document for reference:
HTH
Leon
* Please rate useful posts.
03-13-2006 06:58 AM
IP classful routing is not supported in 4500. The command ip classless is not supported as classless routing is enabled by default.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/relnotes/ol_5184.htm#wp16976
03-13-2006 08:47 PM
Hi
Thanks to all for help
thanks
biplob
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: