cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
389
Views
0
Helpful
5
Replies

4507R catalyst switch port connect/disconnect

hassanimagid
Level 1
Level 1

hi,

I have a big problem with a 4507R catalyst switch(The all port are 1Gb).

When I configure a port to 1G, this port connect, disconnect,connect, disconnect ...

But when i configure this port to 100M it's ok.

The pb is that the all port are busy, i don't have a free port to pluged the cable.

I can't restart the catalyst.

Please help me!! because it's very urgently!!

It exist a solution without restart....

In advance thank you

5 Replies 5

Hi,

I have always the same pb.

Please help me!!

Sure you have a cat 6 8 wire patch cable . Gig takes all 4 pairs of wires to run correctly . I also have always left the port as auto to runn gig . Also if you hardcode the switch you have hardcode your nic too .

Yes, the cable is ok.

I have tested with an other cable and i have the same pb.

Please help me

set speed/duplex to AUTO on 4507 port and server NIC.

Then shut the interface and then no shut.

see if it helps ...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco