4507r redundancy sup question

[ciscoforum]

I want to put a 2nd super ws-x4516-10GE into 4507R. Is there any service outage during the sync? Thanks.

[Roberto Salazar]

No, there should be no service outage for configurtion. But be aware of the uplinks on switches with redundant superviosrs. When you select TenGigabit Ethernet uplinks on WS-X4516-10GE and WS-X4013+10GE Supervisor Engines in RPR or SSO mode, only TenGigabitEthernet 1/1 and 2/1 interfaces are available. Similarly, when you select Gigabit Ethernet uplinks, only GigabitEthernet 1/3, 1/4, 2/3, and 2/4 interfaces are available. When you select to use both uplinks concurrently, TenGigabitEthernet 1/1 and 2/1 interfaces and GigabitEthernet 1/3, 1/4, 2/3, and 2/4 interfaces are available.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_2_31s/conf/rpr.htm

Please rate all posts.

[ciscoforum]

Thanks Roberto

So if I understood correct, the 2nd port on each sup will be auto disabled when I turn on the redundancy feature, right? If I initially have two 10G uplinks on the primary, i have to move 1/2 to 2/1 right?

Thanks

The other question I have is:

How do I verify the sync is completed via commands?