Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

5505

How can I check CPU utilization on 5505, not the RSM module but the switch side of it? I am running ver. 4.5. I am sorry I could not find it on Cisco's web site.

Thanks,

5 REPLIES
New Member

Re: 5505

Ps -c

Remember it shows the utilization in reverse.

5505(enable) ps -c

CPU usage information:

Name CPU-Usage Invocations

--------------- --------- -----------

Kernel and Idle 97% 0

Flash MIB Updat 0% 165

runTimeDiag 0% 101

SynDiags 0% 4954

SynConfig 0% 36545334

In this case, it is 3 % utilized.

New Member

Re: 5505

How did you get 3%? Is it 100%-97%?

Thanks,

New Member

Re: 5505

yes sir :)

New Member

Re: 5505

I am sorry for another question. Where did find this command? I've looked everywhere on Cisco's website and I couldn't find it.

Thanks again,

New Member

Re: 5505

Well, this command is replaced with a generic "show processor cpu" in later codes (5.x)

It is mentioned in this URL

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sft_6_1/cmd_ref/sl_w_cmd.htm#xtocid1050316

but i don't see much documentation for it. I work in TAC and so I had used it before.

115
Views
0
Helpful
5
Replies
CreatePlease login to create content