Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

5509 Sup3 hangs after loading etherenet blades.

I am deploying 2 5509 switches in a School, (donated items)...but one of the switch just wont boot past the loading of the 24 port eth modules.

does anyone have an insight to this issue.

my Hyperm connection is 9600, 8-N-1-N

Enter password:

2004 Apr 06 10:56:50 est -04:00 %MLS-5-MLSENABLED:IP Multilayer switching is ena

bled

2004 Apr 06 10:56:50 est -04:00 %MLS-5-NDEDISABLED:Netflow Data Export disabled

2004 Apr 06 10:56:50 est -04:00 %SYS-5-MOD_OK:Module 1 is online

2004 Apr 06 10:57:07 est -04:00 %SYS-5-MOD_OK:Module 9 is online

2004 Apr 06 10:57:23 est -04:00 %SYS-5-MOD_OK:Module 7 is online

note this last line...this happened after power-down

2004 Apr 06 11:ð

2 REPLIES
Purple

Re: 5509 Sup3 hangs after loading etherenet blades.

Not sure what you are asking here , this bootup looks normal even to the point it is asking you for a password . The last line is just a line it tried to put in as the unit was being powerd off , nothing to worry about .

Community Member

Re: 5509 Sup3 hangs after loading etherenet blades.

The point is the boot process does not go to the Prompt (eg. Cat5500> )...i need to access the console,/

Cant do a break to reset the password or just enter "ENTER" at the password prompt.

I've tried different console settings, moved the ethernet blades around.

Slot 5 and 6 are disabled (different problem but this can be resolved once i have access to the switch).

I am just getting a flashing cursor at the last line.

If someone knows some Undocumented tips or tricks to reset the password, i have all cisco documentation...but none works.

thx.

101
Views
0
Helpful
2
Replies
CreatePlease to create content