Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6500 / CATOS / All ports Error Disabled / sh module status OTHER

HI all,

We a 6500 box with CATOS, after reset the module 6 all the ports are in orange colour, all of them shows an error disabled status and the sh module output shows an OTHER status. Could be a hardware issue?

Any idea?

Thanks in advance

1 REPLY

Re: 6500 / CATOS / All ports Error Disabled / sh module status O

Please try to reset the module again.

Run the test on the module " show test module 6 "

It will tell you problem with the module. Before running the test, set the test diagnostic level to complete using the command.

set test diaglevel {complete | minimal | bypass}

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_8_1/cmd_ref/setsy_tr.htm#wp1078719

HTH, Please rate if it does.

-amit singh

766
Views
4
Helpful
1
Replies