Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6500 CatOs L3 ethernet port

Hi all,

I know how to configure L3 uplink to router from 6500 ios switch.

interface g0/1

no switchport

ip address x.x.x.x x.x.x.x

same thing how will i do it on 6500 CATOS with msfc?

Regards,

Rajesh

4 REPLIES
Purple

Re: 6500 CatOs L3 ethernet port

msfc

conf t

inter vlan XX

ip address xxx.xxx.xxx.xxx

on the layer 2 supervisor

set vlan XX slot/port

New Member

Re: 6500 CatOs L3 ethernet port

Thanx glen...I am wondering if we configure multiple ports on that vlan in sup what will happen?

how msfc sense that is this port for L3uplink?

Regards,

Rajesh

Cisco Employee

Re: 6500 CatOs L3 ethernet port

Hi Rajesh,

You cannot configure a purely layer 3 port in CatOS as you can in IOS.

The closest method to doing this is what Glen described, which is still a layer 2 port with an associated layer 3 virtual interface on the MSFC.

In IOS, as you know, you can configure a physical port to be a layer 3 interface, but this isn't possible in CatOS.

HTH,

Bobby

*Please rate helpful posts.

Purple

Re: 6500 CatOs L3 ethernet port

The answer is yes on the supervisor (layer 2 )you can put as many ports into that vlan as you want .

302
Views
3
Helpful
4
Replies
CreatePlease to create content