Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

6500 Error Detection

How can I disable all kind of error detection including appletalk on 6500? I have appletalk routing turns ON, but lot of VLAN interface will show down because 6500 found misconfiguraion on workstations. Please advice.

1 REPLY
New Member

Re: 6500 Error Detection

Inband syslog messages are generated when transmit or receive errors are detected. By default, inband syslog messages are disabled.

But if it is enabled,you can use the following command to disable it ":set errordetection inband disable"

For more information on this,you can use the following URL:

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a00800c65e5.html

77
Views
0
Helpful
1
Replies