cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
388
Views
0
Helpful
4
Replies

6500 Native/High Avail - Switch between Sup Mods

jrgarrigues
Level 1
Level 1

Hello,

I have a 6500 in native mode with dual sup2 modules. How can I switch between the active and standby supervisor mod/msfc? I am in a lab now, and can do this by reloading, but I know there must be a better way.

Thanks in advance,

John

1 Accepted Solution

Accepted Solutions

Bobby Thekkekandam
Cisco Employee
Cisco Employee

Router#redundancy force-switchover

View solution in original post

4 Replies 4

Bobby Thekkekandam
Cisco Employee
Cisco Employee

Router#redundancy force-switchover

Thanks many bthekkek.

You wouldn't happen to have a URL for any documentation on this would you? This command gets me where I want to be, but I'd like to know more about it. Thanks again,

John

There are 2 different ways in configuring reduandcy between the Sups one is by doing in SSO and the other one is RPR method.

The following links dicuss about these modes as well as about the command lines required to have them configured in ur boxes

RPR & RPR+

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a0080160a91.html

SSO

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a008027e4cd.html

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a00802e4a9c.html

regds

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: