Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

6500 - #set port broadcast 0.00%?

have any of you seen this in your configs without explicitly entering it. is there any other commands that makes the software automatically envoke this command. i saw this while running 5.2(3).

2 REPLIES
New Member

Re: 6500 - #set port broadcast 0.00%?

Maybe by setting it to 0.00% by default effectively disables broadcast supression?.

If it was enabled and working but set at 0.00% the port would not pass any broadcast traffic whatsoever.

New Member

Re: 6500 - #set port broadcast 0.00%?

I understand what the commands does, but I am trying to figure out if there are other command line interface commands or configuration commands that makes the IOS automatically enter this command into the config.

109
Views
0
Helpful
2
Replies