I have two 6504 switches, MSFC's in both. serving what I'd like to have as a 3 subnetted vlan network which consist of 1 subnetted class C.
All of my servers have two nics and are connected to each of the two 6504's.
a. Primary - Production classC/26
b. Secondary - Failover & Backup classC/26
c. DMZ classC/26
I'd like to make the A 6504 the primary for prodcutin and dmz traffic and the B 6504 the primary path for Backup traffic. I'd also like the B 6504 to serve as a fialover in the event that first switch or it's connection the to core fails.
1. Is there a way to do this with MHSRP?
2. What should my Vlan configuration be? Master - Master ?
You can use multiple HSRP configuration for load balancing and making active/active configuration with failover for each other in your architucture,check out the below link for brief explanation with configuration of MHSRP in network.
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does