Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

6506 - SUP720-3B - Ip routing

For the moment, we don't want to active routing on this 6506. I enter the command no ip routing + ip default-gateway ... and it works fine

Pb : When i reload the switch, ip routing is active automatiquely !!!

Is this a bug or a bad configuration from my part ?

4 REPLIES

Re: 6506 - SUP720-3B - Ip routing

Hi,

Did you save the configuration?? You need to save your running configuration to your startup configuration! You can do the same by entering either of the following commands:

- copy run start

or

- write

Hope this helps!

Regards,

AbhisheK

Please rate all helpful posts!!!

New Member

Re: 6506 - SUP720-3B - Ip routing

I save it

Re: 6506 - SUP720-3B - Ip routing

Hi there,

When you have saved it issue the command "show start" to check the startup config and to make sure that your command is in there.

If for some reason it isn't working, then you can always take the ip addresses off the vlans except for the management one. Then it'll have nothing to route with!!

Hope that helps

LH

Please rate all posts

New Member

Re: 6506 - SUP720-3B - Ip routing

when i save it, no ip routing command is neither in startup and running.

323
Views
5
Helpful
4
Replies