cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
249
Views
0
Helpful
1
Replies

6509 and Power Supplies

gaban
Level 1
Level 1

We have a 6509 with a 1300w redundant power supply connected to 110V. If our 6509 is Fully populated will one PS be able to keep it up and running or do we need 220v.

1 Reply 1

jmaines
Level 1
Level 1

Gaban,

This depends on the type of modules you have installed in the 6509. Total power available for the 1300W power supply is 27.46 amps. Add the amount of power consumption for the modules you have installed currently and subtract it from the 27.46. This will tell you if you need to upgrade the power supply. You can find information at the following link: http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a008007f9a2.html#46335

Hope this helps.

Josh

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco