3 3 48 10/100BaseTX Ethernet WS-X6348-RJ-45 yes ok
5 5 48 10/100BaseTX Ethernet WS-X6348-RJ-45 yes ok
7 7 48 10/100BaseTX Ethernet WS-X6348-RJ-45 yes ok
8 8 48 10/100BaseTX Ethernet WS-X6348-RJ-45 yes ok
9 9 48 10/100BaseTX Ethernet WS-X6348-RJ-45 yes ok
WS-X6K-SUP1A-2GE SAL0607J6HG Hw : 7.1
Fw : 5.3(1)
Sw : 6.3(7)
WS-F6K-PFC SAL0603GU2J Hw : 2.0
WS-X6348-RJ-45 SAL06334L43 Hw : 6.1
Fw : 5.4(2)
Sw : 6.3(7)
WS-F6K-VPWR Hw : 1.0
We have been experiencing the below line card errors which has occasionally affected single ports or sometimes all ports on a WS-X6348-RJ-45.
2002 Oct 28 14:58:57 GMT +00:00 %SYS-3-SYS_LCPERR3:Module 3:Coil Pb Rx Underflow Error - Port #20:
2002 Oct 28 14:58:57 GMT +00:00 %SYS-0-SYS_LCPERR0:Module 3: Coil Pb Rx Parity Error - Port #20:
This has now occured on approximately 5 out of 25 of the newly installed modules. At first I have been putting this down to a faulty ASIC and replacing the cards. I am consolidating the serial numbers in case of a faulty batch. The DOA rate seems suspicously high!
Has anybody experienced this problem whilst running Catos 6.3(7)? Did a software upgrade fix the problem.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...