02-09-2006 05:15 PM - edited 03-03-2019 01:46 AM
Below is the error message of 6509 ; Please help to find the root cause. Thanks!!
Device Name = 6509
Facility = FIB
Severity = 3
[Mnemonic] = FIBDISABLE
Description = Fatal error, slot/cpu 2/0: IPC Failure: timeout
02-09-2006 11:26 PM
Please look at the following TAC case doc:
http://www.ciscotaccc.com/core/showcase?case=K20285193
We will need more details on the issue to dig deeper into it than this.
Regards,
Leo
02-09-2006 11:34 PM
hi
I have found a bug id matching the error message which you have mentioned up in ur mail..
do find more details about the same and also the workaround..
CSCuk44685
Symptoms: If an online insertion and removal (OIR) occurs on the slot of a line card with interprocess communications (IPC) traffic running, the forwarding information base (FIB) on the other slots or on a secondary route processor (RP) may be disabled.
The following error messages are logged on the router:
%OIR-6-REMCARD: Card removed from slot 0, interfaces disabled
%HA-5-SYNC_NOTICE: OIR sync started.
%HA-5-SYNC_NOTICE: OIR sync completed.
%OIR-6-INSCARD: Card inserted in slot 0, interfaces administratively shut down
%SYS-3-CPUHOG: Task is running for (2000)msecs, more than (2000)msecs (1/1),process = OIR Handler.
-Traceback= 4043F544 404D667C 404D7698 404EEB94 404E01B4
%SYS-3-CPUHOG: Task is running for (4000)msecs, more than (2000)msecs (1/1),process = OIR Handler.
-Traceback= 404D6680 404D7698 404EEB94 404E01B4
%SYS-3-CPUHOG: Task is running for (6000)msecs, more than (2000)msecs (1/1),process = OIR Handler.
-Traceback= 4043F56C 404D667C 404D7698 404EEB94 404E01B4
%SYS-3-CPUHOG: Task is running for (8000)msecs, more than (2000)msecs (1/1),process = OIR Handler.
-Traceback= 404D6680 404D7698 404EEB94 404E01B4
%HA-5-SYNC_NOTICE: OIR sync started.
%FIB-3-FIBDISABLE: Fatal error, slot/cpu 2/0: IPC Failure: timeout <<< <<<<<<< !!!!
Conditions: This symptom is observed on a Cisco Route Switch Processor (RSP) router that is running Cisco IOS software.
Workaround: There is no workaround. The FIB may be reenabled by entering the no ip cef distributed global configuration command followed by the ip cef distributed global configuration command.
regds
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: