You must have entered the 'no fabric switching-mode allow bus-mode' or 'fabric required' commands. Enter 'fabric switching-mode allow bus-mode' or 'no fabric required' commands and your bus only blades will power back up.
could you please throw light on the model of the equipment youre tryin to troublehsoot.Assumin it to be Catalyst 6500 series switch the problem could be Crux-128 fabric module is not supported on WS-c6513 chassis.
Replace the module that the chasis supports or try for the software upgrade.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...