My company has a large investment in Catalyst 6509s.
Im looking on adding an Unchannelized DS3 point-to-point circuit.
I have to accommodate only one of these circuit connections.
Rather than purchasing Flexwan blades for the 6509s and V.35 modules on my Adtran T3SU 300 I can purchase a T3SU 300 Ethernet Bridge Module and bridge IP from the module to a FastEthernet port on the 6509.
My IOS is c6sup22-jsv-mz.121-19.E1.bin
Im confused on setting up IEEE 802.1Q Tunneling and Layer 2 Protocol Tunneling or do I need to use Integrated Routing and Bridging (IRB).
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...