I have a new w2k server plugged into a 6509 switch. The server was installed by someone else but I setup the 6509. The server was accessible but now it is not. When I do a sho cam dyn mod/port, I get an empty list. When I do the same for other new servers, I get the MAC address of the server. The port shows it is connected.
I have disabled/renabled the port. I have set the port to 100/f and auto-negoiate.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...