Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

6509, Media module not showing

We have a couples of new 6500-e (SU 720)

with CME T1 modules on it

I can not see the configuration and "show hard", but it show on "show module". Also, I can sess into the module.

Anyone knows about why I can not make configuration changes via console port ?

We use 12.2(18) on SU 720.

Any suggest is appreciated.

SW_RE_L#sh ver

Cisco Internetwork Operating System Software

IOS (tm) s72033_rp Software (s72033_rp-IPSERVICESK9_WAN-M), Version 12.2(18)SXE2

, RELEASE SOFTWARE (fc1)

ROM: System Bootstrap, Version 12.2(17r)S2, RELEASE SOFTWARE (fc1)

BOOTLDR: s72033_rp Software (s72033_rp-IPSERVICESK9_WAN-M), Version 12.2(18)SXE2

, RELEASE SOFTWARE (fc1)

cisco WS-C6509-E (R7000) processor (revision 1.2) with 458720K/65536K bytes of m

emory.

Processor board ID SMG0929N84W

SR71000 CPU at 600Mhz, Implementation 0x504, Rev 1.2, 512KB L2 Cache

Last reset from power-on

SuperLAT software (copyright 1990 by Meridian Technology Corp).

X.25 software, Version 3.0.0.

Bridging software.

TN3270 Emulation software.

1 Virtual Ethernet/IEEE 802.3 interface

4 FastEthernet/IEEE 802.3 interfaces

65 Gigabit Ethernet/IEEE 802.3 interfaces

1917K bytes of non-volatile configuration memory.

8192K bytes of packet buffer memory.

SW_RE_L#

SW_RE_L#sh mod

Mod Ports Card Type Model Serial No.

--- ----- -------------------------------------- ------------------ -----------

1 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX SAL092644ZJ

2 5 Communication Media Module WS-SVC-CMM SAD0924013E

3 6 Firewall Module WS-SVC-FWM-1 SAD085008TC

4 6 Firewall Module WS-SVC-FWM-1 SAD085102JC

5 2 Supervisor Engine 720 (Active) WS-SUP720-3B SAL092858QM

6 2 Supervisor Engine 720 (Hot) WS-SUP720-3B SAL09285B01

1 REPLY

Re: 6509, Media module not showing

Hi

You have a seperate image for CMM which is not bunlded with the SUP image of MSFC image.

you need to chek out whether your CMM module meet this factor.

•Supervisor Engine 720 requires the CMM to run Cisco IOS Release 12.3(8)XY6 or a later release.

•Supervisor Engine 720-3B/3BXL requires the CMM to run Cisco IOS Release 12.3(8)XY6 or a later release

do check this link for more info..

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/relnotes/ol_6314.htm

regds

116
Views
0
Helpful
1
Replies