05-13-2002 01:27 PM - edited 03-01-2019 09:42 PM
I pasted my router config to my MFSC router. When I do a sh start or run, I only see a partial config. But, when I type sh ip int brief I see my interfaces and the same for sh ip protocols. Why am I seeing only a partial config without interfaces or router block info? Doe's layer 2 need to be up in order to see the full router config? What am I missing!
05-13-2002 01:39 PM
What you are seeing is NOT expected ? Please provide the software version and an example output. You may open a TAC case.
05-13-2002 08:02 PM
See if your MSFC is in boot mode
Regards
-Prashanth
05-17-2002 06:24 AM
I was having trouble erasing the config, it may have been the Hyper Term settings. Once I erased the config and pasted, it took and all is well.
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: