Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

6509 MFSC

I pasted my router config to my MFSC router. When I do a sh start or run, I only see a partial config. But, when I type sh ip int brief I see my interfaces and the same for sh ip protocols. Why am I seeing only a partial config without interfaces or router block info? Doe's layer 2 need to be up in order to see the full router config? What am I missing!

3 REPLIES
New Member

Re: 6509 MFSC

What you are seeing is NOT expected ? Please provide the software version and an example output. You may open a TAC case.

Cisco Employee

Re: 6509 MFSC

See if your MSFC is in boot mode

Regards

-Prashanth

New Member

Re: 6509 MFSC

I was having trouble erasing the config, it may have been the Hyper Term settings. Once I erased the config and pasted, it took and all is well.

Thanks

106
Views
0
Helpful
3
Replies