I have a 6509 with 2 x MSFC2 cards installed. We had a power outage and the following happend:
The Cat6509 did not start properly, the 1st PFC2-MSFC2 module was in fault and the second one was okay. When logging onto the console port The 1st PFC2-MSFC2 card was in ROMMON mode this was manually booted it and we got a "bad log" message. But the 1st module was now back ok (LEDs and SHOW MODULE command). Unfortunately, performance was very poor, especially on IPX at the time of the connection of the clients.
- At this time, routing was then active (HSRP) on the 1st module and switching on the second module.
- 1st module was de-inserted again but things did not improve at all.
- Then, 1st module was put in back and I removed the second module and this put everything back in proper operation. That is where we are right now.
I agree, open a TAC case. if proper information was not collected during the whole issue, there is slight chance that 100 % explanation can be achieved unless ofcourse TAC has seen such a behaviour or failure scenario before.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...