Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

6509 Port ErrDisable w/ Compaq NIC's

I am running a 6509 switch with Compaq DL360's connecting to the box, using teaming NIC's in a redundant fashion. What is occuring is the ports are being turned to errdisable where the Dl360's are plugged in. We reset the ports and they seem to work for a while. Any ideas?

3 REPLIES
Anonymous
N/A

Re: 6509 Port ErrDisable w/ Compaq NIC's

Try the command, "set errordetection portcounters disable"

New Member

Re: 6509 Port ErrDisable w/ Compaq NIC's

You've got errors on the ports.

Propably caused by a duplex mismatch.

Try to configure both ends (switchport and NIC) to fixed settings.

One end configured for auto-negotiation and the link-partner configured to full-duplex will cause a duplex mismatch and you will have problems as you report.

New Member

Re: 6509 Port ErrDisable w/ Compaq NIC's

You've got errors on the ports.

Propably caused by a duplex mismatch.

Try to configure both ends (switchport and NIC) to fixed settings.

One end configured for auto-negotiation and the link-partner configured to full-duplex will cause a duplex mismatch and you will have problems as you report.

85
Views
0
Helpful
3
Replies