Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6509 SCP Communication Error on FLEX WAN Module

>i have two 6509. These two 6509 have to connect to remote sites via leased

>line.

>

>So i have two FLEX module at each 6509, with a WAN module located at each FLEX module.

>

>However, after booting up, the FLEX LED module at one 6509 remains red

>(while the LED at the other 6509 is green in colour).

>

>Except this, the 6509 seems OK.

>

>The following shows the log upon booting up

>

>2002 Jul 20 02:08:07 %PAGP-5-PORTTOSTP:Port 3/3 joined bridge port 3/3

>2002 Jul 20 02:08:07 %PAGP-5-PORTTOSTP:Port 3/4 joined bridge port 3/4

>2002 Jul 20 02:08:08 %PAGP-5-PORTTOSTP:Port 3/6 joined bridge port 3/6

>SCP Communication error with Module 4

>2002 Jul 20 02:08:10 %SYS-5-MOD_OK:Module 4 is online

>2002 Jul 20 02:08:16 %SYS-5-MOD_OK:Module 15 is online

>

>Any idea what SCP communication error is..

>

1 REPLY
Cisco Employee

Re: 6509 SCP Communication Error on FLEX WAN Module

Serial communications protocol defines the protocol used to exchange messages between the Supervisor CPU and the line card in question.

Besides the RED status light, everything is ok? There was some cosmetic bugs issues related to this error message. What versions of software are you running on the Supevisor and MSFC.

I would suggest looking a the following for any issues. You may want to open a TAC case:

show test 4

show diag

show tech

console to the flaxwan module from the designated router "ipc-console 0", and get "sh tech" and "sh log" from the flaxwan card

169
Views
0
Helpful
1
Replies
CreatePlease to create content