Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6509 Upgrade

I recently upgraded the Memory & CatOS on my 6509 Core Switch. The switch has dual sup1a engines w/ MSFC2 installed. I upgraded to 128 Megs of Memory and to CatOS 7.6.9 from 6.4.21. I now notice a difference when doing a show ver where it doesn't tell me how much memory is available on the standby sup engine only the active sup engine. Is this normal? I seem to recall when I first upgraded the Sup Engine it listed both engines and their memory specs. Also when doing a show version I get the Model of the Sup Engine listed twice. Is this normal as well? Here is the show version & sh module. Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Re: 6509 Upgrade

the output of the show mod and show version you've provided is correct. showing the supervisors both twice as you see is normal.

the version you have 7.6.9 displays only the module 1 memory statistics. this is normal.

as far as the OS is concerned, only 128mb exists and can be used. (each sup has its own 128mb for operation. the standby sup does not reflect its memory statistics in the show version of 7.6.9)

2 REPLIES
Blue

Re: 6509 Upgrade

the output of the show mod and show version you've provided is correct. showing the supervisors both twice as you see is normal.

the version you have 7.6.9 displays only the module 1 memory statistics. this is normal.

as far as the OS is concerned, only 128mb exists and can be used. (each sup has its own 128mb for operation. the standby sup does not reflect its memory statistics in the show version of 7.6.9)

New Member

Re: 6509 Upgrade

Thanks for the response.

104
Views
0
Helpful
2
Replies
CreatePlease login to create content