Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

6509 with msfc2 refusing telnet

The msfc2 is refusing telnet. If I console in and try seesion 15 on the switch I get this error.

"session: Unable to tunnel to Router-15 (57)"

I cannot reload the whole 6509 due to the switch sup reloading as well and I have servers that cannot lose connection due to being in production. Is there a way to console into the msfc? A switch in the sup mode config to console directly.Can I rester the msfc without powering down the whole unit. Thanks.

  • Other Network Infrastructure Subjects
1 ACCEPTED SOLUTION

Accepted Solutions

Re: 6509 with msfc2 refusing telnet

Hi,

this could be due to MSFC in rommon or some misconfiguration.

Console into the switch and try command " switch console " , you will get to MSFC for sure and will take it further from there.

Keep me posted on what is the problem with the MSFC.

:))

regards,

-amit singh

1 REPLY

Re: 6509 with msfc2 refusing telnet

Hi,

this could be due to MSFC in rommon or some misconfiguration.

Console into the switch and try command " switch console " , you will get to MSFC for sure and will take it further from there.

Keep me posted on what is the problem with the MSFC.

:))

regards,

-amit singh

97
Views
0
Helpful
1
Replies
This widget could not be displayed.