6509 with PFC How can I limit a ports bandwidth to a max of xyzk sec?
Im running CAT os 7.3,
I have been playing with the QOS policer and I cant see to limit a port's speed to a max of say 64k a sec. I set the Policy and the ACl and map it to the port, I see packets being dropped but when I test, I am still able to pull bandwidth beyond the 64k. I basically want to rate limit a port so it cannot transmit beyond a certain speed.
Re: 6509 with PFC How can I limit a ports bandwidth to a max of
set qos acl ip very_l dscp 0 aggregate very_limited IP x.x.x.x any
set qos policer aggregate very_limited rate 32 burst 13 drop
set qos acl map very_l 5/47
Now Here is the issue. The Device on 5/47 is a PIX firewall. I set x.x.x.x to the IP address of the PIX firewall. I set a pc on the other side of the pix firewall and it got ip address y.y.y.y uses the pix as the gateway. I extected it to limit the pix traffic....
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...