Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6513 Ethernet port mis-match

Hi

has anybody ever seen an issue on the 6513 chassis in relation to fast Ethernet cards whereby even though both ends are hard set to 100mb full the card remains set at 100mb half. Even though the port is installed at 100mb full it defaults down to 100mb half.

1 REPLY
Anonymous
N/A

Re: 6513 Ethernet port mis-match

If you are connecting a workstation to the switch port, check if this document helps you :

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00800a7af0.shtml

Otherwise, see if there are any known issues with the hardware/software version that you are using.

84
Views
0
Helpful
1
Replies
CreatePlease to create content