6513 Inventory Reports on RME 3.3

Community Member

‎08-01-2002 11:23 PM

I have Ciscoworks 2000 installed with RME version 3.3. We have recently installed some 6513's and whilst I have been able to update Ciscoview to "see" these devices, RME will only see them as generic SNMP. Is there a fix for this ??

Labels:

Other Network Infrastructure Subjects

3 REPLIES

Blue

‎08-02-2002 09:15 AM

6513s are supported in the new RME 3.4 if you wish to upgrade with additional new device support.

For adding upport for 6513 in your existing RME 3.3, you need to get the RME 3.3 IDS patch from TAC.

Community Member

‎08-05-2002 03:52 AM

I have had a look at the TAC but can't seem to find the patch, could you let me know the Url ??

THANKS

Blue

‎08-05-2002 07:44 AM

You may need to open up a TAC for this.

Latest Documents

PFRv3 channel state questions

Created by Vasilii Mikhailovskii on 04-23-2018 05:06 AM

This document gives several answers on frequently asked questions for PFRv3 channel state behavior. Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st... view more

VPN and static NAT problem

Created by Jacopo Belcredi on 04-23-2018 04:07 AM

Symptoms The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921). The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN. I couldn't connect to the hos... view more

Cisco ESW-520-24P Switch Configuration

Created by Kevin DeMott on 04-19-2018 01:49 PM

We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des... view more