Im having a problem on 6513 catalyst switch, lets say I have 4 VLANs so I had created the VLANs on the switch and then configured the interfaceVLANs and the IP addresses and the routing is done correctly between VLANs, all PC/Servers in different networks ping each other. I also had DHCP server in my server farm. So IP Helper-address was configured under every interfaceVLANs to point to the DHCP server and all clients in different VLANs got their IPs from the DHCP correctly. I also had a Firewall Blade module installed in the catalyst 6513 core switch.
My question/problem is how to configure this FW Blade module with the equivalent command to the IP helper-Address??
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...