Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

7120 Router

I have this 7120 router which seems to be okay, but when I type "Sh Ver" I get this output.

120#sh ver

Cisco Internetwork Operating System Software

IOS (tm) EGR Software (C7100-IS56I-M), Version 12.1(5)T9, RELEASE SOFTWARE (fc1

)

TAC Support: http://www.cisco.com/tac

Copyright (c) 1986-2001 by cisco Systems, Inc.

Compiled Sat 23-Jun-01 06:29 by cmong

Image text-base: 0x60008960, data-base: 0x6177C000

ROM: System Bootstrap, Version 12.0(5r)XE, RELEASE SOFTWARE (fc1)

BOOTFLASH: EGR Software (C7100-BOOT-M), Version 12.0(5)XE5, EARLY DEPLOYMENT REL

EASE SOFTWARE (fc1)

INSUL7120 uptime is 7 weeks, 5 days, 20 hours, 14 minutes

System returned to ROM by power-on

Running default software

cisco 7120-4T1 (EGR) processor (revision A) with 57344K/73728K bytes of memory.

Processor board ID 15055864

R527x CPU at 225Mhz, Implementation 40, Rev 10.0, 2048KB L2 Cache

Last reset from power-on

Bridging software.

X.25 software, Version 3.0.0.

Basic Rate ISDN software, Version 1.1.

2 FastEthernet/IEEE 802.3 interface(s)

4 Serial network interface(s)

4 ISDN Basic Rate interface(s)

Integrated NT1's for 4 ISDN Basic Rate interfaces

125K bytes of non-volatile configuration memory.

40960K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).

8192K bytes of Flash internal SIMM (Sector size 256K).

Configuration register is 0x2102

When I type "Show flash:" I get the error message, "Can't open device not ready". Looks like the Flash card is not working, but then from where it is loading the IOS. I do have this command in the configuration file.

boot system flash disk0:c7100-is56i-mz.121-5.T9.bin,

but again, if the device is not ready then it should not boot.

2 REPLIES
Silver

Re: 7120 Router

Try a "dir disk0:" instead and see if that works. Disk usuallly denotes an ATA filesystem and not a flash card.

Hope that helps,

Don

New Member

Re: 7120 Router

the image is located on disk0:....do the following command to see image...dir disk0:

95
Views
0
Helpful
2
Replies
CreatePlease login to create content