Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

7200 rommon

It will not boot from bootflash. How do I trasnfer a new boot image when xmodem isn't a recognized command? and I can't boot into any kind of boot mode

1 REPLY
New Member

Re: 7200 rommon

the 7200 routers and up load up a little differently.

First go into rommon and change your confreg to 0x2101 and reset

rommon 1 > confreg 0x2101

rommon 2 > reset

If your boot image is valid you will come up in boot image mode, Then just set up an interface and copy an ios to flash from tftp. Change your config-reg back to 0x2102 and reload.

Router(boot)(config)#config-register 0x2102

If both the ios and boot image are corrupted, the only way to replace them is to put the pcmcia card into another router and copy the image from there. Or swap cards with another 7200 and try to boot from that.

Here is an excellent link for this:

http://www.cisco.com/en/US/products/hw/routers/ps359/products_tech_note09186a00800a750e.shtml#download

Good luck.

hth

BT

374
Views
5
Helpful
1
Replies
CreatePlease to create content