I have 11 sites all tied in to the district office with 2600 routers. I would like some help on having the 7200 router route all traffice through the proxy server before it goes out to the internet...also any one know of good monitoring software I can go out and purchase please advise.
All of this is OpenSource or GPL software, you don't have pay any licensing fees to use the software (in general terms), your only cost is time and hardware, usually a server with two NICs, and processor of P2/450 or better.
First, read, read, read, then setup the proxy and firewall, then practice with your local network getting through the proxy. Then play/config the router to get traffic going where you want. Web proxy traffic will be config'd at the user workstations to go through the proxy server, and then you use an ACL to deny all http traffic that doesn't come from the proxy. If you read the above link on proxy and firewalling, things will become clear.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...