We continue to get incorrect data from our 7206's when monitoring the HSSI port. Does anyone have the correct OID to get ifIn/OutOctets? That would be a good start to try and determine are we even looking at the correct value.
For interface speeds of less than 20Mbps using 32-bit counters like ifInOctets/ifOutOctets are ok, but for High Speed interfaces > 20Mbps, you need to use the 64-bit counters (ifHCInOctets etc). Did you try using any other snmp tool to compre the results?. Also can refer to http://www.cisco.com/warp/public/477/Gen_NMS/38.html
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...