Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

7206vxr multichannel T1 set up

I need an example of how to set up load balanced T1's. I have an exsisting T going to a remote site. I want to have two, and have them load balance.

2 REPLIES
Bronze

Re: 7206vxr multichannel T1 set up

There are several ways to do this, if you are using static routes for your existing connection, all you need to do is add another route for the second connection. For example:

ip route 0.0.0.0 0.0.0.0 serial 0 <- existing route

ip route 0.0.0.0 0.0.0.0 serial 1 <- add this route

Here is a url on load balancing with CEF in case you have CEF enabled.

http://www.cisco.com/en/US/products/hw/modules/ps2033/prod_technical_reference09186a00800afeb7.html

New Member

Re: 7206vxr multichannel T1 set up

This is an example of the serial int on the T1 that is now up.

carl-7206rt02#sho int s1/0:0

Serial1/0:0 is up, line protocol is up

Hardware is Multichannel T1

Interface is unnumbered. Using address of FastEthernet0/0 (xxx.xxx.xx.xx)

MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,

reliability 255/255, txload 2/255, rxload 9/255

Encapsulation HDLC, crc 16, Data non-inverted

Keepalive set (10 sec)

Last input 00:00:04, output 00:00:00, output hang never

Last clearing of "show interface" counters 14w5d

Input queue: 0/75/0/810 (size/max/drops/flushes); Total output drops: 1216546

Queueing strategy: weighted fair

Output queue: 0/1000/64/1216469 (size/max total/threshold/drops)

Conversations 0/18/16 (active/max active/max total)

Reserved Conversations 0/0 (allocated/max allocated)

Available Bandwidth 1152 kilobits/sec

30 second input rate 60000 bits/sec, 15 packets/sec

30 second output rate 13000 bits/sec, 13 packets/sec

1287213463 packets input, 1507393866 bytes, 0 no buffer

Received 0 broadcasts, 2837 runts, 0 giants, 0 throttles

4283 input errors, 279 CRC, 0 frame, 0 overrun, 0 ignored, 802 abort

1289146656 packets output, 659257274 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

2 carrier transitions

no alarm present

Timeslot(s) Used:1-24, subrate: 64Kb/s, transmit delay is 0 flags

82
Views
0
Helpful
2
Replies
CreatePlease to create content