Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

7206VXR PDSN-high CPU rate.

Dear All

Thank you for read my question. and my english express is a not perfect and not good ^^ please understand and help me!

Current, we have been changed NPE400 to NPE-G1 because we got too much CPU rate.

We are using this modle for PDSN and when we changed to NPE-G1 the CPU is 60% but our customer want to less than 60%.

Do you have any solution or how can I check more detail traffic rate? I mean if the CPU get more higher than 60%, i have to use some command.

But I just knew a few commande for check it.

I only knew show process cpu, show process cpu | inculde 0.00, show 7200.....

Could you tell me the other command for check ?

One more thing, we got Five 7206VXR for use PDSN but all PDSN has a high CPU rate. it's not only busy time.

It's a normal they record 60% or over 60%.

Our cutomer serving CDMA 1x Data service to user. and this is our running IOS version , c7200-c6is-mz.123-14.YX4.bin.

So, which part do I have to check for reduce CPU rate?

Thanks & Regards,

218
Views
0
Helpful
0
Replies