7304 nse100 FE Management Port configuration question
How can the F0/0 FE Management Port be used? Since the 7304 has a redundant NSE100 prossesor card I would like to use this port two ways as a remote router access port for management and as a standard FastEthernet interface. Is configuration and advertising of the interface IP address the same as standard FastEthernet interfaces?
Re: 7304 nse100 FE Management Port configuration question
The FastEthernet port on the Cisco 7304 is for management purposes only. Any other use of the FastEthernet port is not supported. This statement is according to the configuration notes of 7304.So, it cannot be used as a standard GE port.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...