I have 6509 connected to (2) 3550 switches. Vlan 20 and Vlan 30
Customer has an existing network with 10 token ring subnets and all connected to 7507routers and the Ethernet 1/0 is connected to 1st Cat5000 (172.16.20.0 subnet, ServerFarm1) and Ethernet 1/1 connected to 2nd Catalyst 5000 (172.16.30. subnet, ServerFarm2)
I like to connect two networks so customer can easily migrate the servers from cat5000 to cat 3550 switches.
This is what I am going to do move subnets 172.16.20.0 and 172.16.30.0 to 6509 switches. Connect 7507s Ethernet 1/0 and 1/1 to 6509 respectively as new subnets for example, 172.16.100.0 and 172.16.200.0) to 6509 logical interfaces, int vlan 100 and int vlan 200.
Create vlan 20 and 30 as well in Cat5000s, and then connect to 3550. Now any users behind 7507s will be able to reach server farms from 7507 to 6509 to 3550s and finally to cat5000s.
1) Will it work?
2) The link ports on7507 1/0 and 1/1 to 6509 would be trunk ports or just regular ports.
For example, on 6509
I will create,
vlan 100 and 200 and move two port 3/1 and 3/2 to vlan 100 and 200 respectively
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...