7513 ISDN-E1-portadapter caused problems with fastheth-port adapter?
i have an cisco 7513 running an enterprise ios (123-1a).
the router has a rsp4 and two vip2-50 modules . the first vip-module contains two fasteth portadapters
and the other vip module contains an 8-port serial port adapter and an 8-port e1-isdn port adapter.
on the serial pa there are 5 serial lines (frame-relay and hdlc) connected and on the e1-pa there are two
lines which are bundled via ppp multilink.
the problem is that the router cannot transfer packets greater than 200bytes out of the fast ethernet interfaces when the e1-lines are connected. its no lan-problem because when the e1-lines are removed everthing works fine.
the e1-port adapter and the vip-modules have been replaced, so the hardware seems to be ok.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...