I am trying to get two 775 M series isdn routers to demand dial each other and route IP.
I have been through the example configs etc and they now dial and log into each other.
However, I cannot seem to find the correct command to get them to route packets through each other onto the networks. The manuals seems to assume that this will be done automatically (or the answer is so simple that they over look it).
The routers can see the Mac addresss of the machines on the LANs but not the IP addresss.
I believe I am possibly missing three things.
The default gateway on the LAN profile, or I havent set the ip address of the LAN profile correctly. Or an association of the LAN profile to a port?
Can any one point me in the correct direction please.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...